Tycon Systems EZ-Bridge-Ultra2-LR Long Range Wireless Point to Point Bridge System

15.70 (in)
15.70 (in)
10.00 (in)
$25.00 (Fixed Shipping Cost)


The EZ-Bridge Ultra2-LR is a long range high capacity 100Mbps+ and high power 250mW outdoor wireless bridge system operating in the 2.4GHz unlicensed spectrum. The complete system allows for ultra high bandwidth connections between 2 buildings up to 8 miles or more apart with good line of sight.

The EZ-Bridge Ultra2-LR creates a transparent bridge between 2 sides and passes all network traffic including VPN and DHCP. You can think of it like connecting a CAT5 Ethernet cable between the 2 points.

It is the perfect high capacity plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge Ultra2-LR units can be connected in a mesh configuration to allow interconnecting more than two sites.

The system supports 802.11n TDMA and 802.11g OFDM for backward compatibility. The advanced MIMO antenna system offers 18dBi of gain in a compact and visually pleasing package. The antenna also offers great front to back performance which helps reduce interference. A snap-on radome is included to protect the antenna from snow, ice, hail and crazy birds who sometimes like to nest in antennas.

With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.

Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power supplies. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer.

The antenna can be installed with Vertical Polarization or Horizontal Polarization, depending on customer preference. The corrosion resistant bracket system allows mounting to a pole with up to 2.25" diameter or wall mounting using the included wall mount brackets. The bracket provides +/- 20 degrees vertical tilt and unlimited horizontal adjustment. The system comes with 24V PoE (Power Over Ethernet) power inserters and 2 rolls of shielded and outdoor rated 75' long CAT5 cable assemblies. The shielded outdoor cable helps to protect against EMI from lightning and ESD from wind.

The EZ-Bridge Ultra2-LR comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including two powerful 18dBi 802.11g/n MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, 24V PoE (Power Over Ethernet) power inserters and two 75' Shielded Outdoor Rated CAT5 cable assemblies.

The EZBR-0516+ management interface is IPv6 enabled, https enabled. Logon username is fixed. The password can be changed, and there are no rules for password length or content.


  • High Throughput to 150Mbps and High Power 250mW Electronics.
  • Transparent Bridge
  • 18dBi MIMO Antenna
  • Vertical or Horizontal Polarization
  • Pole or wall mount
  • Attractive radome for protection from elements
  • Plug and Play Setup
  • Selectable 20MHz or 40MHz channel width
  • No driver needed. Easy configuration thru web interface and remotely. Multiple Operating Modes. Antenna alignment utility. Bandwidth management. Data Logging and statistics graphing.
  • 64 and 128bit WEP, WPA and WPA2 Encryption. Most powerful data security available
  • DHCP Client or Server - Simplifies network administration
  • MAC Address filtering - Ensures secure network connection in all operating modes
  • VOIP Friendly QOS - Quality Of Service mechanism to ensure good Voice Over IP performance
  • SNMP - Compatible with your favorite network management software
  • Includes two 75' shielded, outdoor rated CAT5 cable assemblies
  • Includes 2 wall mount brackets
  • Power Over Ethernet (POE) - Antennas can be mounted up to 100meter (300ft) from the power source

EZBR-Ultra2-LR Specifications

Data Rates: 6-150 Mbps



2.4GHz 18dBi Dish Antenna, 8 deg AZ and 8 deg EL Beamwidth, >23dB front to back

Operating Distance: up to 15miles line of sight

Network Topology

Ad-Hoc, Infrastructure


IEEE802.11n, 802.11a, 802.3, 802.3u

Operation Modes

Point to Point Bridge, Access Point, Client

Bridge or Router

 Power Requirements

Power Supply: 100-240VAC 50/60Hz

EZ-Bridge® Ultra2-LR: 12VDC to 24VDC

Avg Power Consumption: 5.5W

Processor: Atheros MIPS 24KC 400Mhz

Interface: 10/100Mbps RJ-45 LAN Port

 Regulatory Certifications

FCC Part 15 / UL

Memory: 32MB SDRAM, 8MB Flash

IP Auto Configuration: DHCP Client

 RF Frequency Band

2412 ~ 2462 MHz


MAC Address Filtering, WEP/WPA encryption, Hide SSID in beacons, Layer 2 isolation

 Available Transmit Power

802.11a/n: 4 to 23dBm

Management Configuration

Web-based configuration (HTTP)

Console configuration (SSH)

SNMP Protocol

Modulation Technology

802.11a: OFDM

802.11n: TDMA


Firmware Upgrade

Upgrade firmware via web browser

 Operating Channels

2.4GHz  12 channels supported at 40MHz width


Antenna Physical Dimensions (diameter x D)

400mm dia x 254mm depth (15.7” dia x 10”)

 Receive Sensitivity (Typical)

802.11g/n: -94 +/-2dB @ 14Mbps

802.11n: -75 +/-2dB @ 300Mbps

Complete System Weight

9.07 kg (20 lbs)


Temperature Range Operating:

Operating: -30°C to 75°C (-22°F to 167°F)

Storage: -40°C to 80°C (-40°F to 176°F)

Extra Information

Tycon Systems
15.70 (in)
15.70 (in)
10.00 (in)
23.00 LBS